Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by diesel0621
-
Clamp Ring Tolerances
Jassco, What tolerances are achievable on a 10/11" diameter based on your experience?- diesel0621
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Clamp Ring Tolerances
Hello, I have a sheet metal part that is rolled in to a cylinder, roughly 10.5" inner diameter (+/- .010"), with two flanges at TDC, used to mechanically fasten to a lifting plate. We have had some poor workmanship in these parts from our vendors and I believe it may be the lack of GD&T, or...- diesel0621
- Thread
- Replies: 2
- Forum: Drafting Standards, GD&T & Tolerance Analysis
