Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by diasmanuel

  1. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    The driven shaft i want to connect it´s not keyed. Thanks.
  2. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    BobM3 I did search on rotary coupling but i didn´t find anything. As i can´t have a hole through the main shaft/arbor i need to feed radially. I must have a coupling between the driven and driving shafts. NomLaser, Yes i´m driving dyno. Yes i have to test motor perfomance as fast as...
  3. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    Shaft size 15.00 mm, torque 10 Nm , speed 1000 r.p.m
  4. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    The air powered collet you describe it´s to heavy and big for this aplication but the slip ring coupling sounds good. Do you know any supllier? As i´ve already mentioned before there are hydraulic bushings that are operated with a screws, so if i could connect a hydraulic tube instead,this would...
  5. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    Thanks for you quick answer. Yes, it works but i need to insert and remove the motors from the test machine at very hight rate aprox. each 15 seconds. The taper lock takes much time to install and to remove. I know that theres is a hydraulic bushing that uses a screw to increase the pressure in...
  6. diasmanuel

    QUICK LOCKING SHAFT MECHANISM

    Hi all, I need help. I need to design a machine for testing electrical motors. The problem is how to attach a motor that has a round shaft to the tester Machine, and in between there is coupling to compensate alignment errors ? A collet sistem can not be installed because there is no hole on...
See more

Part and Inventory Search

Back
Top