Recent content by diaamsaber

Dear John, thank you for your reply, and yes I mean at at some point in the sequence, I want the 'section' to appear, at some later point have it disappear I'm using NX8

Hi guys , I need to make a section as a step in the assembly sequence, to display a component path through the other component (e.g shaft inside housing), so is it possible?

thanks guys for the reply :) I've found the way, by adding all those parts to one folder in the team center, and in the Nx at the team center navigator open the the desired folder and select all the components, right click then select add as component. all the components will be added...

thank you phillpd but I'm working with the Team Center, so I can't do this :(

even if I just want to add them and without making any constraint ?

thanks for your reply :) I understand this, but I need to add multiple different parts not the same, so do you know any alternative technique instead add them one by one

Hi Guys, I need to add like 500 parts to the same assembly ,but I need to do it simultaneously not one by one so could anyone help me please

thank you Mr. john for your reply :)

Hi, guys. I'm having an assembly which consists of sub-assemblies, each sub-assembly has its own sequence so how can I call out those sequences in the main assembly sequence.

Thank you very much for your respond :) but I think that NBR is much better, because the resistance to grease here some useful link http://www.jjshort.com/Rubber-Properties.php

hey guys , I need your help please I worked in a factory and we are using a copper greasing niplle and we want to replace it with a one made of Sbr-1500 the working conditions are - NAOH 4% concentrating in water - greasing with a lithium base - Temperature up to 80 C so could Sbr resist...

thanks for your answers guys :)

Hi Guys, I'm searching for the Yield Strength for the Bohler k100, so could any one please helps me Thanks