Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DHerbert

  1. DHerbert

    AISI S200 Cutting and Patching cold formed metal studs

    @DaveAtkins, Thanks for responding. These are a series of nonloadbearing studs - a low height wall approximately 10 feet long. I need to keep the 'notch' to allow electrical cable to pass through, so I can't sister a stud next to them.
  2. DHerbert

    AISI S200 Cutting and Patching cold formed metal studs

    I have a construction site where the flanges of 3-5/8" metal studs need to be notched. AISI S200, Standard for Cold-Formed Steel Framing section B2.2 allows cutting and patching if using and "approved design" or an "approved design standard". Any suggestions on how to patch metal studs?
See more

Part and Inventory Search

Back
Top