Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dgroff2029
-
Bylaser 4400 "Overcurrent on tube 10"
Krugtech....thanks for your reply. I actually got a tech from Alphatronics in house today to take care of this and several other issues. This forum will probably be my lifeline for awhile though. I spent 14 years in plastic extrusion and due to a plant closure, have found myself working with...- dgroff2029
- Post #3
- Forum: Laser engineering
-
Bylaser 4400 "Overcurrent on tube 10"
I keep getting this error message on one of our Bystronic lasers. After acknowledging the error and restarting the cut a couple of times it goes away for a few hours. Can someone please tell me where I need to be looking to eliminate this issue. Thanks- dgroff2029
- Thread
- Replies: 7
- Forum: Laser engineering
