Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Denney Zenge
-
Standard washer deformation under reduced bolt torque
The dishing of the 316 washers is caused by insufficient bearing area between the washer face of the capscrew and the I.D. of the washer. I calculate worst case bearing area of only 0.190 sq.in. The lock-collar nut subtracts ~ 35 in-lbs. up front. It also matters which end of the fastener you...- Denney Zenge
- Post #13
- Forum: Mechanical engineering general discussion
