Ok. I notice this basic error i have made. I have modified the drawing, and it seems right to me now (i.e. considering the outer contours is important).
I have attached the updated pic now. Please tell me what do you think about this. Looking forward to your...
Thanks to both of you for this feedback. I am only concerned about the Bushings locations relative to each other and not to the outer contours.
I will study about Composite tolerancing and figure out on how to use it.
Last question: For knowledge sake, if my location of the pattern was important...
Hi All,
I have little experience with using GD&T. I have a 8mm plate in which there are 12 bushings. The location of these bushings are critical.
In-order to control this, i have made 1 bushing as Datum B, and given position tolerance of 0.3mm. All the other bushings are referenced to this...
