Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by decS

  1. D

    General profile governing limits

    Thanks for the feedback, all.
  2. D

    General profile governing limits

    It’s not stated, but you can’t reasonably enforce the draft angle of that drill tip at the base of the wider cylinder. Is there any known convention that general surface profile has an application limited to surfaces that are not holes?
  3. D

    General profile governing limits

    The note would go something like this: “This is a minimal dimension drawing. The CAD model is the master for all dimensions not shown on the drawing. Part profile 0.025 A B C unless otherwise stated” I’ve also attached an example of one of the points in question.
  4. D

    General profile governing limits

    I have a quandary that appears quite often on prints I work with. A given part has a general profile to govern undimensioned features. On said part I have a blind, threaded hole called out on the print to Y14.6 standards. There is a section view of this hole with a cylinder depth called out...
See more

Part and Inventory Search

Back
Top