I'm inserting some hoses into a assembly, and I want to figure out once I have the hoses in what is the true length of the 3d spline that I used to make the hose. Thanks in advance.
I just want to thank all of you for your help. Taking a little advice from every response got me on the right track. Thanks once again for taking the time out to answer my post.
Derrick Langley
Could someone give me clarificaion on this matter. I'm trying to create a 3d sketch in an assembly (SW 2001 plus). I selected my face to start my spline and I want to end my spline on another face on another face. I can't see that face in the current view(iso). To see the other face I rotate my...
I have two plates; one square, one circular. there are three post that go inbetween them at a triangular pattern. I mated the post with the square plate. When I try to mate the circular plate with the post I can't get the triangular patterns of the plates to line up. Every time I try to align...
the cut and paste worked well. Thank you very much for all your help. There for a while, I was becoming very furstrated at this program. Again, thanks a bunch!
In SW2001 I'm not able to import a dxf into a blank template. When I try to open a dxf in 2001 and make it a drawing template in doesn't seem to work properly. I go to edit sheet format and my dxf disappears. Once I save as a drawing template and then try to use that template. It still scales...
I tried that and I wasn't able to select that option in the drawing properites. Plus whenever I scale the part that I bring into the drawing it scales the border too. I don't understand why it does this. If I use the default template from SW2001 it will not scale the border. So I used the...
