I tried that one but I just get the message "No valid design table instances were found". I did however find a cheat to get this to work. I put two design tables on one sheet, one above the other. Then what I have to do is copy one to the top three rows and exit the DT. Then re-open the DT...
I was thinking of equations but my they would be so complicated that I might as well type in all the dimensions.
I have 288 unique dimensions describing the root, tip, chord lengths and angles of attack for a wind turbine blade. All these values are calculated from an Excel sheet that I made...
I am working on a part which does have more than 256 changing dimensions, has anyone come up with a solution to adding these to the design table yet?
Dave
