Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Dazza421

  1. Dazza421

    Tolerances of ISO 2768 cumulative or not?

    Im going to step in here because Im having this discussion at work currently. If 2 holes are dimensioned as 200 and 220 from an edge, The manufacturer can only assume that the 2 holes have a relationship to the edge which is paramount to the correct proformance of the part. ie the 2 holes locate...
See more

Part and Inventory Search

Back
Top Bottom