Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by dazma
-
What stress values (safety factors)
nozzle reinforcement is done to bring down the stress concentration at the joint due to removal of material. When the area provided is more or equal to that of area required, the stress concentration is assumed to be nil. But if the reinforcement is less the stress concentration would be higher...- dazma
- Post #5
- Forum: ASME (mechanical) Code Issues
-
How do you figure out GPM
If your flow system is a closed loop system, Differential pressure across the condenser coil will be equal to = K* (Kinetic energy) Where KE = (1/2)*density* (velocity)**2 K = pressure drop co. If you know the pressure drop across the condenser and the pressure drop coeficient of the...- dazma
- Post #2
- Forum: Pipelines, Piping and Fluid Mechanics engineering
-
Pipe flowing compressible fluid
Dear Luiz, You have to find out the Mach no. of your steam flow. If it happens to be less than 0.3 you can neglect the compressible effects and use the same formulas applicable for non-compressible flow. Generally any industrial compressible flow rate are chosen such that the Mach. No. does not...- dazma
- Post #7
- Forum: Pipelines, Piping and Fluid Mechanics engineering
