Nice answers!
The idea is having only 3 cells
I see one needs some programming to do so; I don't know about it my colleagues do.
Thank you all
regards,
Thank you for the fast answer.
The "goal seek" is nice; I didn't know it; but it is not what I was looking for; it takes some time
The nested IF idea could work, I have to check.
Also making different scenarios with pulldown menus to choose in each case what we want to introduce....
The best...
Hi there,
I tried to be specific with the subject but I don't know if I succeeded.
In excel, I have a formula (output, A) in one cell which is the addiction of other two (inputs B and C)
But, If I want to introduce a value in the formula (A) and I want to get the value of B with the same...
Hi there,
I want to create a simple geometry with the Design Modeller for an axisymmetric analysis.
I create different sketches, then surfaces from each sketch.
The problem is in the end I only get one body (and one part), so I can't give different properties to each surface.
Does anyone...
Hi there,
I was asked to make a simulation of a reinforced concrete block (16x10 m2)in 3 thickness: 1.0 m 1.5 m and 2.0 m in order to choose the optimum value
This turned out to be more complicated than I expected.
I made some assumptions. The first one the concrete is isotropic in all the...
Hi there,
I contacted the author of the paper and he agreed there are mistakes.
I have a 50 mm Radius feet (10.9 quality) against a 16MnCr5 plate
The point is I can't say how much weight we place, but what's the maximum one
cheers,
Hi,
This system is already manufactured and working.
I didn't realise the materials we were using
For the plane (plate) is 16MnCr5 which has a minimum tensile strength of 1000MPa
For the sphere (screw) the quality is 10.9 so 940 MPa
I'll do the calculations, but I'd like to ask someone to...
Hi everyone,
Thanks for the answers
- The xcalcs page is very cool. I made some analysis and I got the following results:
Average compressive stress: 1340 MPa
Maximum compressive stress: 2010 MPa
The contact is steel against steel. Supposing a yield strength of 200 MPa I'm out of the 3-4...
Hi ztengguy,
Yes, I'll check the statics. and each component. This is not the problem
What I need to know is what happens in between these two parts (spherical and planar)
Cheers,
Hi there!
I need to check the maximum weight we can put on a platform we have.
There are different parts between this platform and the floor. It doesn't seem difficult to check each part, but the platform is place on the top of three feet like the one in the attached picture: a sphere touching...
Hi everyone,
I have to perform a vibrational simulation of a 16x10m2 block in order to compare different thickness: 1 - 1.5 - 2 meters
This doesn't seem very challenging except for the point the block is made out of reinforced concrete. I've never done a simulation with concrete; I tried some...