Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DavidJNAI

  1. DavidJNAI

    AWS D1.1 Weld Access Holes

    In figure 5.2 for rolled sections the weld access hole for the top flange is shown as coming off the flange at an angle all the the way out from the point of the groove. If this is done the backing will not fit flush with the bottom of the flange. Is it acceptable to have the access hole be...
See more

Part and Inventory Search

Back
Top Bottom