Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by davehay

  1. davehay

    Santoprene part not shrinking enough length wise.

    Injection molding a 2 cavity, tunnel gated part out of Santoprene 8211-55, the shot weight is 1.0 lbs. The part is not shrinking length wise. Using all of the suggestions to allow the part to shrink. i.e. hot mold, fast fill, minimal pack, fast cycle. One thing remains, should I run a colder...
See more

Part and Inventory Search

Back
Top Bottom