Recent content by dave11282

VE1BLL that Cradlepoint looks fine, @ £200 , is a snip thanks

hi apologies if this covered before, we have a 440v, 3 phase, 60hz supply on ship, motor control panel , using a 440v/230v transformer, to supply lighting circuit, should this the '0v' of the secondary be earthed ? ( ie wire connected from 0v to chasis of skid, control box ?) thanks

Hi I need a competitively priced 3G router, which can be configured for VPN, Ipsec , etc anyone recommend good quality price, is for industrial application thanks

Hi I need to connect a Bradley SLC500 to E1100 HMI, over ethernet, can anyone give me links to application notes , how to set this up thanks

Hi can standard tri rated cable be used in an EExd enclosure ? think zone is zone 1 thanks

many thanks guys application is for a marine cable that is being terminated at shore, I believe it is some kind of data carrying cable, at the minute Tyco and rossengineeringcorp looks good, any more welcome, many thanks

hi I am trying to source a medium voltage switch, 3 pole, able to work at 3.6kv, 320mA. any ideas appreciated thanks

Hi all I need an ozone sensor with a 4-20mA output to PLC please can anyone recommend any UK maufactures'/suppliers thanks

Marmite thanks for link Dave

Hi all I am trying to source some CAD drawings for Schneider (Merlin Gerin) distribution boards Isobar 4 16 way 3phase? (I did contact Schneider, but they 'could not find any'!!) they must exist somewhere on some server somewhere, any pointers would be great thanks

we had huge issues using westermo modems last year, TDW33 they have had firmware issues, the swedes rehashed all their kit, and it was not properly tested, in the end we set the HMI with a PPP connection, connected to FX3u in transparent mode. Key point with PPP is that all nodes have same...

thanks for replies. I didnt think there was a BS standard. UK generation is 240V. EU requirement for single phase harmonisation is 230V. UK still generates 240V. And is unlikely to change due to huge implications on generation network. Dave

Hi all are they any BS standards that state that it is recommended or must switch the neutral (so the neutral is taken thru a set of n/o on the motor contactor) as well as the phase to a single phase motor 240v motor? thanks Dave

we also noticed that the new TEC we had in was now wound differently to the one we evaluated. Which surprised us! The connections are different in the motor terminals. Same 0.75kw spec / chassis ? Dave

many thanks guys, Jeff, I did carry out IR test, 800 meg ohm. Do you have URL for TEC? thanks Dave