Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Dave a M
-
Piping Isometric odd angle shaded offset
Sent again with isometric drawings attached correctly, looking to find out if reading correctly for correct angle roll of pipe and angle req for arc length for fabrication. Hope somebody can correct me and give detail if I am wrong Thank you Dave a M- Dave a M
- Post #2
- Forum: Student Engineer General Discussion
-
Piping Isometric odd angle shaded offset
file:///Users/davemelrose/Downloads/IMG_8895.jpgfile:///Users/davemelrose/Downloads/IMG_8894.jpgfile:///Users/davemelrose/Downloads/IMG_8893.jpgfile:///Users/davemelrose/Downloads/IMG_8892.jpg Trying to work out if I am doing it correctly using the correct angle for arc length roll and also...- Dave a M
- Thread
- Replies: 1
- Forum: Student Engineer General Discussion
