Thanks Harry. That is just what I was looking for. The machine is a 2001 ES2000 with from what I can tell has most of the recent features. I do have the manual but the section on ejector set up is limited and certainly doesn't explain what technique to use.
David
yes, I understand this. That is why I am asking if I will be able to overdrive the ejector retract parameter past the mechanical stop of the ejector system to ensure that the pins will be at their proper distance.
1) can I do this?
2) is it commonly done?
3) will it cause premature wear on...
First off, let me state that I am new at this and am building knowledge as I go. So just bear that in mind.
I have recently purchased a nissei 120ton electric machine to make some parts. I am in the mold design process and have a question about the electric ejector rods/bars.
How do they hook...
