Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DAS1001

  1. DAS1001

    Stress intensity factor at "T" fillet weld

    Thanks, guys. You are confirming my initial suspicion that this is not a very good design. Tmoose, The maximum value for P is what I am trying to calculate. I have typically set P = 1,000 lbs, calculated stresses, then scaled P up until stresses reach allowable values. I don't know the...
  2. DAS1001

    Stress intensity factor at "T" fillet weld

    Hello, new member here. I have been asked to analyze the welded assembly shown in the attached pictures, and determine ultimate load P. The problem is, I have spent my career dealing with aluminum aircraft structures, and have basically zero knowledge about welds. At the area of interest, the...
See more

Part and Inventory Search

Back
Top