Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DarkAngel00

  1. DarkAngel00

    cutting parallelism

    ok, tryed to adjust focus mechanically and the problem is gone, now i have 0.12-0.08mm of difference between top and bottom. tryed to enlarge beam to 18mm (13 original) and pieces will be welded on bottom side. thanks to all
  2. DarkAngel00

    cutting parallelism

    Monday i'll try everything. By enlarging beam diameter i have to lower the Speed?
  3. DarkAngel00

    cutting parallelism

    This is the result of focal test... How to correct? I have marked where the "spessimetro" (in italian, i don't know its name in english, sorry) don't enter the gap.http://files.engineering.com/getfile.aspx?folder=50052115-9015-4b7d-8b00-d78def03873c&file=IMAG1265.jpg
  4. DarkAngel00

    cutting parallelism

    Thanks. Tomorrow i re-run the test and set it. Try with low gas pressure and small beam. Thanks to all for answer
  5. DarkAngel00

    cutting parallelism

    the machines it's buyed used but revised, mirror and source ar new, it run from october and we encountered many problems, most of them solved, this remain unsolved. don't know if autolas mirror is ok. there is no "before" :) or i don't know if the machine works correctly where it was first...
  6. DarkAngel00

    cutting parallelism

    today i cut 10mm steel (s355jr) the cut is good but after measuring the piece the top side is almost perfect, 60.00mm from drawing 59.98mm measured really good) but the bottom of the piece in smaller, ideal must be 60.00mm but measured is 59.66~59.75mm if you measuer in different point. how can...
  7. DarkAngel00

    how parameter works?

    what i'm trying to say is: load the nc code, enter in menu 1->5->3 "tech table" (or something like this, i'm italian and manu is in italia and say "tabelle tecnologiche" reset to defautl ALL the table. and it's all ok but i want to know how this parameter modify the cut for example: cutting...
  8. DarkAngel00

    how parameter works?

    i run for years a mazak 3000w all the parameter were passed by nesting software from amada in the nc and run great. now i changed company, and i have to use a trumpf L3050 5000w te cutting table are on the machine, trumpf technician and onboard help say that focus poin it's at the tip of...
See more

Part and Inventory Search

Back
Top