Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by DannoTheManno
-
General Profile Tolerance on Basic Dims -- CMM Inspection
Basic dimensions which use the title block tolerance. We are inspecting the basic dimensions to title block tolerances, but we are not reporting. We also inspect those dims/features for profile per the profile note. Only thing that will be reported (in regards to those basic dims) is the profile...- DannoTheManno
- Post #5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
General Profile Tolerance on Basic Dims -- CMM Inspection
I've got a customer print with true position on holes, and basic dimensions locating said holes. There is also a general note "Unless otherwise specified, all features located using basic dimensions shall be [<profile> .020|A|B|C]." Per the print, ANSI Y14.5M - 1982 applies. Can I assume the...- DannoTheManno
- Thread
- Replies: 9
- Forum: Drafting Standards, GD&T & Tolerance Analysis
