Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DanielSj

  1. DanielSj

    Define area with specific tolerance?

    Hello! I'm trying to design a part that you could say has two parallell faces interconnected with a shaft. It is important that the finished part has a tighter tolerance around the shaft (e.a 200+-0,5) than the areas further away from the shaft (e.a 200+-2). How do you specify this on a...
See more

Part and Inventory Search

Back
Top Bottom