Thanks for all your advice guys! I am a good designer, but obviously I am young so have room for improvement! And I will look at the job rather than the 3D package they use... As someone said it may be good to use a different one, and get a different perspective... I just don't want to lose of...
I'm not actually sure what industry I want to work in yet to be honest! I only graduated 2 years ago. I currently work in the Semiconductor Industry, and I have also worked in the Gas Industry. I fancy a change though now, as I've been in this last job for almost the full 2 years.... I'm just...
Thanks for your responses. Basically I currently work at a company who use SolidWorks, and I was thinking of doing some training on other 3D modelling packages to further my career. A job has now come up using Unigraphics, and I wondered if I should 'stick it out' and find a job still using...
Hi All,
I currently use SolidWorks 2005. I'm looking into using Unigraphics. I've never used this package before. Is it similar to SolidWorks at all? I know that SolidWorks and Solid Edge and ProE are all very similar...as in the basic modelling is the same. But i have heard nothing about...
Since the upgrade to SP3.0, I've been having lots of problems with mate errors, and especially losing/invalid faces. I know this is a problem if you change the parts, and so the face ID changes. However, I have been losing mates with parts that have not been changed by myself or anyone else...
