Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by DANGERBOY
-
Machining plastic
The key to machining plastic in general is a sharp cutter w/ lots of chip clearance. There for I would suggest a HSS 2 flute end mill. You can get plastic to cut with carbide, but HSS is better!- DANGERBOY
- Post #3
- Forum: Machines & Machining engineering
