Recent content by daanh

Thanks Bill. I thought I read somewhere that it can measure smaller torques, but that the beep function (beeping when a certain torque is reached) doesn't go lower than 29.5. We'll see... Gunnar, how does that device of you work?

I don't need high accuracy. +/-5% is fine. I just ordered this to measure torque of a moving shaft. Measuring the speed is easy, so I guess I'm set. :)

No, I literally just emailed them. A colleague of mine had the suggestion to take a battery drill and just measure the current to the motor and the current, and determine the speed and torque with that.

In the Netherlands. I emailed them with this question, thanks!

Hello, I'm looking for a device with which I can measure the required torque at various rpm's. This way I could map the torque/rpm graph of various machines. Is there some device for sale that can do this? Thanks, Daan Haeyen

I know, I tried using sketch blocks. But even the schematic mechanism is difficult.

I searched grabcad and thingyverse, without luck...

Hi, does anyone have a model of a convertible softtop roof mechanism? Just the bars of course. I'm trying to model one, but it's tough... Thanks, Daan

What do you mean? Back in the part file? Edit: that works, thanks.

OK, this is strange. When I change the units decimals to none, the lenght gets updated, but the angle stays the same. Any thoughts on this?

Hi, I use the 2014-2015 student edition. I see the problem now: I was changing the precision in the dimensions section. I should change the units in the unit section. Very confusing. Thanks! Daan

Hi, I have the same question as in this thread: http://www.eng-tips.com/viewthread.cfm?qid=204860 The solution stated there doesn't work for me. The weldment cut list stays at two decimals.... Thanks, Daan

Would it be possible to make a rendering very similar to the V-ray one, in Photoworks?

Hmmm, the best rendering is not made with Photoworks... :)

I hate the undo function. It seems there are not a lot of things you can undo. Also, the way changes are saved: I have an assembly open. I open a part of it, edit it, decide it's not good and close it without saving. Then when I return to the assembly, all my changes are still there!! Is this...