Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by cvady

  1. cvady

    Apply stress as input

    Is it possible to apply sigma_x+sigma_y values, as the individual stress values like sigma_x and sigma_y are not available.
  2. cvady

    Apply stress as input

    Hello everyone, Usually, the displacement or loads will be applied as boundary conditions to solve the problem. I would like to apply sigma_x+sima_y as input and solve the problem. Let us assume, sigma_x+sigma_y results are available from some another source like experiments over certain nodes...
  3. cvady

    Applying strain boundary condition

    I do appreciate you guys for your continuous support. I got good insight into the problem.
  4. cvady

    Applying strain boundary condition

    The goal of the analysis is to apply the experimental strains and perform stress analysis in FEA. Are there any tools for performing inverse FEM?
  5. cvady

    Applying strain boundary condition

    Sorry, I have edited the question. I am having strains(E11,E22,E12) from experiments and convert them to displacements(U1,U2).
  6. cvady

    Applying strain boundary condition

    How can I convert nodal strains to nodal displacements? Is there any built-in Abaqus facility for doing this? I have E11,E22,E12 from experiments at all nodes and would like to convert to U1,U2.
  7. cvady

    Applying strain boundary condition

    I have the strain data (at all nodes) from the experiments. I would like to apply this strain in FEA at all nodes. Thanks for your quick reply.
  8. cvady

    Applying strain boundary condition

    Hi, In Abaqus, we can apply displacement, velocity or acceleration as boundary conditions and solve the problem. In the similar manner, how can I apply strain as boundary condition and solve it? I have gone through the Abaqus documentation and could not find it. Any help is greatly appreciated...
See more

Part and Inventory Search

Back
Top