Recent content by csubba

Thanks you! Synchronizing does work by copying the values to the upper level assembly, but it is not a live link, if we changing the value at the lower level it does not propogate up without sychronizing again. As of now it looks like the best bet is to assert at the component level.

Asserting mass to a component (for which I have no write access) in a subassembly (for which I have write access) correctly accumulates the mass in that subassembly. However, one level up, the mass for this component defaults to the 'from design' mass. The assertion works flawlessly if done at...

Thanks Joe, I had not used the "Info, Part, Loaded Parts" function before, I see that the parts are not fully loaded.

When I used a Standalone version of Unigrpahics earlier, I noticed I could not copy geometry between parts using wave geometry linker unless I explicity fully load the part I need to copy from (this I think is because I "use Partial loading" as assembly load option). We now have Teamcenter...

Thank you your solution worked. Chandra.

Hello Guys, need some help with where i need to save the "load_options.def" file so that NX6 can read it back when I bring it up next time. I have had to pick the "load_options.def" file manually everytime. Thanks, Chandra.