Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Csike

  1. Csike

    Expert needed for a web out of center issue

    Csike (Materials)(OP)24 Jan 14 03:37 Dear Colleagues, Recently we placed a claim to a hot rolled section supplier regarding the shape of IPE 240. After thorough measurment, it came out the beams has web out of center problem. The question is now, how we should understand this clause of the...
  2. Csike

    I and H section dimensional tolerances EN 10034

    Dear Colleagues, Recently we placed a claim to a hot rolled section supplier regarding the shape of IPE 240. After thorough measurment, it came out the beams has web out of center problem. The question is now, how we should understand this clause of the standard. the questionned IPE 240 had 3 mm...
  3. Csike

    I and H section tolerances EN 10034

    Dear Colleagues, Recently we placed a claim to a hot rolled section supplier regarding the shape of IPE 240. After thorough measurment, it came out the beams has web out of center problem. The question is now, how we should understand this clause of the standard. the questionned IPE 240 had 3 mm...
  4. Csike

    content of Certificate 2.2 En 10204

    Dear Cpolleagues, Thanks for all of you for the valuable comments! It seems clear now, mech test report (and as I understand even the chemical analisys report) is not a must of the 2.2. certificates, unless it is not stated in the orders. Interesting, isn't it? :-)
  5. Csike

    content of Certificate 2.2 En 10204

    thread367-234594 We got some strange COA EN 10204 2.2 type lately for some S 235 sheets. The strange is, they don't contain any mechanical test report, only chemical analysis. Question: Where can I find out if mechanical test reports are a must or not for COA 2.2 EN 10204. Hope the question is...
See more

Part and Inventory Search

Back
Top