Recent content by cristina2

Hi, I am trying to model with ABAQUS a structure with extreme aspect ratio: talking about a Substrate with aspect Ratio of about 300 (lateral dimensions/thickness) with several films on top of aspect Ratio of about 2 millions (2e6), ie plane vs its thickness. I managed to do this using the...

Thanks a lot everybody; with all your suggestions I could find the answer and also learn Basics that will be very useful for me.

Hi corus thanks; (1) could you please be more specific or make a sketch regarding your answer ? (2) also, assuming that there is no simmetry (in this case there is, but a following case could not have), what is the general way ? If I model the entire block, is it sufficient for me to fix...

Hallo, I must model a structure where I have a Silicon die with some thin film material on top. The film is deposited at high temperature, then cooled down. during cooling stresses and strains are developed inside and partially released by system bending (see attachment). My question is: which...