Recent content by Cranny

Thanks bc. Unfortunately i have some 40 holes on my component so i usually group them by size/type to keep the hole table to a sensible size say 10 entries. This is no problem until you get different holes that happen to have the same bore size. I never seem to be very successful with hole...

Hi, How do i group holes in a hole table by type and not just size? Currently when i use the hole table command it will group different holes that happen to be the same diameter together. For instance if i have a 4.2mm clearance hole and an M5 tapped hole on the same part it lumps both holes...

Thanks fred, i knew it was simple but seemed to be having a mental block with this one. Cheers

i cant seem to delete a hole table i have placed, i cant select to delete or edit. there also seems to be no way of editing an existing table. any ideas?