Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by corrosionguy

  1. corrosionguy

    Pressure gage requirements

    Where does it say in ASME VIII that we need a pressure gauge on a pressure vessel and its requirements. I am trying to find it but no luck. I found some information on hydrotest section but that is not what i need. Thanks, Corrosionguy
  2. corrosionguy

    Operating at 1% above MAOP, down stream of compressor stations

    09091960 I would like to answer your original question. If your burst pressure for an indication is less than MOP of the pipeline then it is considered as a defect and needs to be replaced. Lets take this example MOP of the pipeline = 9000 kPa Burst pressure calculated at defect = 10, 000...
See more

Part and Inventory Search

Back
Top Bottom