Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by condenseddave

  1. condenseddave

    Underground golf cart garage

    I've been asked by one of my top three customers, to provide ventilation for a brand new underground golf cart garage. (The ramp is a former swimming pool!) The golf carts are electric, not gas. At this point, I wish they were gas. There is a battery charger for each one of these 150 36VDC...
  2. condenseddave

    Bonding of metal air ducts required?

    I believe that it is in certain instances, but I cannot recall exactly what conditions must exist to make it a requirement.
  3. condenseddave

    'Fully' hermitic compressors: How to charge and recover?

    "Process tube adapters" (By Robinair) and "Piercing valves" (By Supco, Watsco, etal) are readily available.
  4. condenseddave

    Large duct design reference?

    I meant "DUCT DESIGN". [thumbsup2]
  5. condenseddave

    Large duct design reference?

    http://www.accaconference.com/Merchant2/merchant.mv?Screen=CTGY&Store_Code=ACCOA&Category_Code=SDC Manual "Q", I believe, is just what you're searching for. Manual "T" is also an excellent reference, if you're not super experienced in dust design.
  6. condenseddave

    Central A/C and Furnace Sizing

    HVAC-talk is the place to take this question, but, I'm going to give you a headsup that the answer that you're goiong to receive there is to have a licensed contractor perform a load calculation on your home. Every building is different, and the design conditions differ GREATLY between South...
See more

Part and Inventory Search

Back
Top Bottom