Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by coldshot
-
Hole Callout on Hole Series created holes
I was thinking it might have something to do with that. I'm not sure if my part file was uploaded or not, but it's a single part file with two blocks in it. Tried to attach it again. When I create a Hole Table it shows up in the list. Just thought maybe I was missing something. I guess until I...- coldshot
- Post #5
- Forum: Siemens: UG/NX
-
Hole Callout on Hole Series created holes
John, Thanks for the reply. I'm not making a Pattern Feature, just a single Hole Feature. I attached the my simple part file. I have a block with 2 holes in it. Both created with the "Hole" feature. The first Hole is of Type "Hole Series" (Counterbored), and the second is of Type "General Hole"...- coldshot
- Post #3
- Forum: Siemens: UG/NX
-
Hole Callout on Hole Series created holes
Hello, After making a general hole in a part file and then entering the drafting application, I can dimension the hole using the Radial Dimension command with the Hole Callout method. When the hole is created using Hole Series option, the hole is not selectable in the Radial Dimension command...- coldshot
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
