Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by CMillanR
-
Holes Centered on the piece
Thank you all for your insights and suggestions. I truly appreciate your help in resolving this lingering question I had. I understand that centerlines can be used, but as you say, it's better to use GD&T to locate the hole positions. I'll definitely be putting all of these suggestions into...- CMillanR
- Post #9
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Holes Centered on the piece
Hi, I'm new to this forum. I'd like to know the simple way to represent that holes in the image are centered. Should I use centerlines or dimensions? I hope you can help me. Thank you in advance.- CMillanR
- Thread
- Replies: 8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
