I finally got a set of files to my customer that he said import fine!
I went the save as ProE route. It wasn't working for my customer before, but this time we got it. May be due to a few adjustments I've made to the files over this whole process. Don't know for sure. I did have to perform...
My customer said he tried saving ProE files from my original SW files (he has ProE and SW) and was unsuccessful doing so.
I tried saving the entire assem in ProE earlier today. Halfway through it said it was unable to export one of the parts. Everything else seemed to export. I'll try to...
We did try IGES at the beginning of the process and were getting mixed results, some parts ok, others with errors. The customer preferred STEP so that's what I concentrated on. I've also heard that STEP files are generally more reliable than IGES, but I suppose one should always be tried when...
Thanks for the reply James.
I don't know that the end user is not proficient in ProE. I think he is expecting perfectly stable files with no post import work needed. I am beginning to think it's a pipe dream cause I've been trying to fix this issue for a week now. I was hoping there was a...
I have been trying to send a customer STEP files of parts and assemblies that were created in SolidWorks. My customer is opening the STEP files in Pro-E. They are not opening up perfectly, however. He is running log files when importing and a lot of errors are showing up. Sometimes the parts...
