I have drawings of magnets with physical dimensions, materials, tolerances, etc. How do I add a Magnetic Flux requirement (weber, volt second) so I can measure the magnet when is arrives and be sure that it is fully magnetized? I know how to add this to the drawing literally however where do I...
Does anyone know where I can get a magnet characterized for all four quadrants. Electron Energy use to offer this service but it doesn't show up on their website any longer.
Clyde Hancock
Design & analysis of electric motors and generators
www.motorconsultants.com
I’m looking for some help with respect to skin effect. On a PM synchronous motor, the windings are subjected to the rotational frequency from the PM rotor and to PWM frequency that is driving the motor. I feel that the fundamental frequency of the rotor is the main contributing factor to skin...
I'm looking for information about a winding machine for large diameter wire in a DC armature. I have seen this machine (a long time ago) and I think it was called an "Able" winder. It doesn't wind in the traditional sense (fly, needle, shed, etc.), instead you have to cut the magnet wire to...
I am magnetizing as an assembly.
In some materials you may get 95% of B but only 50% of H, so not good.
How can you have this situation?
Clyde Hancock
Design & analysis of electric motors and generators
www.motorconsultants.com
This is from ExcelCalcs . . . However, it does not automatically update as you make changes. You have to do it manually. For me, not such a big issue.
Clyde Hancock
Design & analysis of electric motors and generators
www.motorconsultants.com
If you are talking about the equation format, they could have been using ExcelCalcs (https://www.excelcalcs.com/). I believe there are others as well. I've used ExcelCalcs for many years. It displays EXCEL formulas as equations.
Clyde Hancock
Design & analysis of electric motors and generators...
Thanks, I understand but I am curious as to how the published data is determined. In other words, what does he magnet vendor due to establish the values they publish?
Clyde Hancock
Design & analysis of electric motors and generators
www.motorconsultants.com
If I subject unmagnetized Neo to elevated temperature but stay below the curie temperature will this adversely affect the magnet when later magnetizing? In other words, will I still be able to fully magnetize the magnet after it cools?
Clyde Hancock
Design & analysis of electric motors and...
