Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by clittle1111
-
Creating cone flat pattern in sheet metal
Don't use sheet metal much. Is it possible to create a rolled cone in solid edge ST6 and then use sheet metal to make a flat pattern? Thanks- clittle1111
- Thread
- Replies: 2
- Forum: Siemens: Solid Edge
