Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ckurre
-
Amada Laser edge detection
Figured it out! There was a typo in the manual, "M121" should have been "G121". Changed that and it worked just fine.- ckurre
- Post #2
- Forum: Laser engineering
-
Amada Laser edge detection
Hello all, I'm trying to get our Amada FO 3015NT to sense the edge of the material and make adjustments accordingly. The goal here is to use factory edges on flat bar and sheet metal while still having accurate hole spacing. I have copied some code from the user manual that I thought should...- ckurre
- Thread
- Replies: 1
- Forum: Laser engineering
