Recent content by ckb614

I think you may need a lesson or two on responding to questions without being snarky. I fail to see how there is ambiguity in the word "buckle" when I'm talking about lifting straps. If asking for advice on this forum means dealing with people like you, then it's not worth my time.

No. It would be something that essentially fold over a small section of the strap to reduce its length and add tension. I should post pictures, but to demonstrate: if you put one finger under a strap and one finger above offset by say 2 inches, then lift the finger on the underside to wrap the...

Nevermind

Is there a type of buckle for lifting straps that allows you to fold a section of the buck over to shorten the length of the loop? And then you can disengage the buckle easily to return the loop to its full length? Let me know if I can clarify. Thanks

I just saved 2 CGRs and put them in a new product. That should be fine

I need to show my product in two separate states. This involves several parts rotating and translating. I tried to do it with the Scene toolbar, but it only allows you to use the snap function and no Manipulate. What is the best way of showing this? I would just save as a new model, but the...

Thanks for all the responses!

If I need to hold and rotate a 120lb load using a motor (at the pivot point) from horizontal to vertical at a distance 10 inches from the pivot point, I would need a holding torque of 1200in-lbs right? Is it possible to increase the holding torque of a motor using gears? or do you just increase...

I have a product with about 30 clamps and I'd like to attach a bracket to each one. Is there a way to do this without have to do each one separately?

We don't have a server. Just a shared external hard drive that gets backed up by carbonite. Our storage drive does not have a screen/cd drive/keyboard etc

My company wants to start using Workgroup PDM. We have a network hard drive in the office that all of the computers are connected to and we'd like to put the Vault there. So far I have only been able to get a vault up and running on a local machine. how can i relocate the vault to the external...

I need either a blade terminal or a pin terminal with a width or diameter of no larger than 1.5mm. Looking for a reliable supplier and not the one from JST or eagleday.com Thanks!

perfect. thank you

What are they called? I can't find them

http://www.dvinfo.net/forum/attachments/jvc-gy-hd-series-camera-systems/1345d1164640965-alternative-hardshell-camera-case-p0001197.jpg