Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by cjevans

  1. cjevans

    Arc Spot Welds

    Is it true that you need a separate procedure for every piece of material you are burning through when preforming a arc spot weld?
  2. cjevans

    AWS D1.3 welding procedure

    I understand I should use a controlled process to maintain a consistent level of quality.. My issue is that these test will be issued out at job sites and the material we will test on always varies in sizes.. I want to be able to order a certain thickness of the materials to carry around and...
  3. cjevans

    Welding Qualification ranges AWS D1.3

    Correct me if I'm wrong but in regards to AWS D1.3 if you can weld 12 gauge steel to a 1/2" steel embed plate then you are qualified to weld anything thinner than 12 gauge (14,16,18,20 etc.).... Also, if you can weld that 12 gauge to the 1/2" steel embed plate then you are qualified to weld 12...
  4. cjevans

    AWS D1.3 welding procedure

    I'm looking to set up a universal welding procedure for my company and I'm confused on which test would give my guys the broadest range of qualification. My guys use a fillet weld with a T-joint.. We mainly weld a 12-16 ga. galvanized sheet steel clip to a 1/4"-5/8" steel embed plate.. My...
See more

Part and Inventory Search

Back
Top Bottom