Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by cires23
-
Hole fits in hybrid joints
Hi, I need to install HST315 fastener in a hybrid joint. Per drawing the hole fit is Class II at composite skin (clearance) and Class IV (interference) in the metallic fitting. If I need to install the 1st oversize at the joint, aircraft SRM does not stated the drilling fit, but to drill...- cires23
- Thread
- Replies: 2
- Forum: Aircraft engineering
