Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ChrisKDe
-
Centre-to-face dimension for RTJ flanges
Thank you for the quick responses. I think The Obturator got my point, though I wrote the wrong request. What I meant was center-to-face dimension according to API 526 (not face-to-face). Means from center of PRV to face of flange. (That's why I referred the former post.) So, I assume, the...- ChrisKDe
- Post #4
- Forum: Safety Relief Valve engineering (PSV)
-
Centre-to-face dimension for RTJ flanges
thread1203-474921 Hi, following the referred thread, my question is: What is the centre-to-face dimensions for RTJ Flanges? Is the "face" the end of the raised face portion or the bottom of the grove? See attached picture for clarification...- ChrisKDe
- Thread
- Replies: 4
- Forum: Safety Relief Valve engineering (PSV)
