Then does everyone agree that table 1 of ISO 2768 is the applicable tolerancing for radii in general and table 2 is only applicable for radii that are for broken edges?
And is it to be assumed that a radii is toleranced by table 1 unless something on the drawing tells you to refer to table 2...
Thanks for your reply Ben.
When I look at the scope of this document under note 3a it reads: "linear dimensions (e.g. external sizes, internal sizes, step sizes, diameters, radii, distances, external radii and
chamfer heights for broken edges);
It gives diameters and radii as examples of linear...
ISO 2768-1 appears to apply to two different types of radii. Radii NOT for broken edges with tolerances per table 1 and external radii that ARE for broken edges with tolerances per table 2.
My question is how is this difference specified on a drawing? How does someone reading my drawing know...
