Guys..... thanks for the input. I am not a programmer, but, I have " picked a lot of things up " in life by diving in. This will help me to start out at least with a tool geared to what I am looking for. Thanks again!
I have an interest in developing my own machine computer interface software with graphics. Which software tools / programming languages best lend themselves to this? I'm sure this is subjective, but, all responses would be appreciated!
Not that I am a pump application whiz, but, I have never seen a closed loop pump operating in suction vacuum without something being wrong. My first suspect is a suction strainer is prior to the suction gauge that is plugged substantially. After that, is the highest point in the piping system...
There are a few things that you may want to consider. If your chiller is relatively new with micro controls, it may have the capability of operating the tower fan as required. If it is a large tower with say, 10-12 fans that may not be an option due to output limitations of the chiller...
There are a few things that you may want to consider. If your chiller is relatively new with micro controls, it may have the capability of operating the tower fan as required. If it is a large tower with say, 10-12 fans that may not be an option due to output limitations of the chiller...
You did not state what the supply water temp was. Is in in the "normal" range of 44-45 degrees? Also, is this a primary only, or, primary-secondary pumping system? I am suspecting it is a primary only system.
:The chilled water flow may actually be excessive. Check the original...
I am assuming we are talking reciprocating compressors here. Seems the first problem is probably the 1 degree "differential" setting. If there are no unloaders on the compressors at lighter loads you are probably beating the compressors to death on starts, not to mention loss of...
