Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Cherrian
-
Stetter motor
Check input data format, ensure that the target angles and corresponding times are correctly formatted and inputted into Adams View. Any discrepancies in the data format can cause unexpected behavior. Check the interpolation settings as well, verify the interpolation settings in adams view. if...- Cherrian
- Post #3
- Forum: Student Engineer General Discussion
