Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by cheezypuff

  1. C

    ID Overlap between the gasket and the raised face flange

    Thanks for all your comments. I didn't think about different schds for the pipe. It make sense that they probably want to make one size gasket to cover different pipe schds., as long as the compression area is sufficient for the pressure rating.
  2. C

    ID Overlap between the gasket and the raised face flange

    I'm using class 150 1 1/2" pipe raised face flange. It has an ID of 1.37" I was looking at the gasket from MMC. For 1 1/2", the gasket ID is 1 29/32". I understand the gasket OD should be between the raised face OD and bolts, but I don't understand why the gasket ID can't be a little bit...
See more

Part and Inventory Search

Back
Top