Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by chattaggie

  1. chattaggie

    Appropriate Contact Gaps

    I'm not an extremely experienced COSMOS user, but from a recent discussion on this with my SW VAR, in this situation I would use "No Interference" in the Shaft OD/Collar ID, the Pin OD/Collar Cross Hole ID, and the Pin OD/Shaft Cross Hole ID. Hope this helps.
See more

Part and Inventory Search

Back
Top Bottom