Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by chaseyama

  1. chaseyama

    GEC CDG16 Puzzle

    Thanks very much for the very useful suggestions. I did a bid of clean up have managed to push current through one of the coils. So far though, I have not gotten the disc to turn. I have not had problems before with previous GEC relays so I suspect went wrong over the years. But I agree with my...
  2. chaseyama

    GEC CDG16 Puzzle

    Ah, DTR2011, I will check that too. There is something which we used for current injection tests on substation relays while I was working on the Railways. It was nicknamed, "Mouth Organ". If you plugged this in, you had direct access, it seems to most of the terminals. I will go and find out...
  3. chaseyama

    GEC CDG16 Puzzle

    Thanks for the great response, especially about the functioning of the shorting contacts. Because the relay is built-in and wired into the training cabinet, I need to undo the wiring from the back of the panel and detach the relay and then do a direct measurement, and direct injection also...
  4. chaseyama

    GEC CDG16 Puzzle

    I have a problem trying to test the operation of a CDG 16 and similar relays on an teaching rack in our university. I do not register any current when I inject at pins 9 and 10. Before injection, I measure 0.8 ohm at these inputs which I thought would have been the relay impedance. On the...

Part and Inventory Search

Back
Top