Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Charan@

  1. C

    Symmetric to Centerline note is given to below drawing attached, need to understand how manufacturer will punch the holes at what tolerance.

    does it means the dimension for the hole position not needed, if not what will be the tolerance will manufacturer control.
  2. C

    Symmetric to Centerline note is given to below drawing attached, need to understand how manufacturer will punch the holes at what tolerance.

    can't we consider the width size .75 +/- .01 and ask manufacturer to maintain half the size for Centerline location ? Ex: .76/2 , .75/2, .74/2 or is it mandatory to show dimension of centerline from one end with tolerance?
  3. C

    Symmetric to Centerline note is given to below drawing attached, need to understand how manufacturer will punch the holes at what tolerance.

  4. C

    General tolerance for angular dimension

    Hello All, I am currently working on several rubber components produced via the molding process and would appreciate your guidance on the general tolerance requirements for angular dimensions in such parts. Could you please confirm if the tolerance table provided (referenced in the attached...
See more

Part and Inventory Search

Back
Top