Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by CENSMR

  1. CENSMR

    Chiller Capacity and System Heat Generation

    I am trying to remove the heat from the hydarulic fluid after it leaves the pump... in fact, after it is done doing whatever work I am asking of it (sometimes none), before returning to tank. MintJulep - I agree/understand that I have to remove less heat from the fluid when doing work , as...
  2. CENSMR

    Chiller Capacity and System Heat Generation

    Thanks for your replies. As for the requested clarifications, I am using a heat exchanger but it is not air cooled. The exchanger is part of the hydraulic system I have, but requires chilled water input, and thus why I have the chiller... to cool this water. As for the electric motor and pump...
  3. CENSMR

    Chiller Capacity and System Heat Generation

    I am trying to use a chiller to cool a hydraulic system, and am trying to verify if I have enough cooling capacity in my chiller. The stated maximum cooling capacity is 10.5KW. My system starts with a 50HP motor (~37KW), and my first question is how much of that in worst case scenario can...
  4. CENSMR

    H7 Clearance Fit

    Thanks for all of your replies. Apologies for not properly searching previous posts/threads - this is my first time using the site and I was not familiar with search techniques or posting guidelines... many google (standard) searches before posting came up empty. Thanks again - especially...
  5. CENSMR

    H7 Clearance Fit

    Where can I find a table providing the relevant fits for clearance fit? I have a hole dimension that is "H7" and I need to find the relevant range. Thanks!
See more

Part and Inventory Search

Back
Top